|
2010 Rule
Modifications for Stadium Pro Lite Trucks, |
|
All Classes:
1. All
vehicles must have a flat, full support gas pedal with a toe hook. Toe
hook must enable driver to pull back on the pedal in the event of a stuck
throttle. 2. No
titanium components are allowed with the exception of the truck and Pro
Buggy Unlimited classes’ engine components, and the engine valve
retainers in the Limited Buggy class. Stadium Pro Lite Trucks 1. Bed
sides must have a minimum of four 1/4 inch minimum bolts or Dzus buttons
evenly spaced at front of bedside and four 1/4 inch minimum bolts or Dzus
buttons evenly spaced at rear of bedside. Bolts or Dzus buttons must have
2 inch washers and be aligned in a vertical fashion. 2. The
mud flap rule now reads as follows: Mud
flaps are required and must extend from 6 inches above center line of rear
axle to 3 inches from ground at ride height. 3.
Flaps must be 14 inches wide and made from hard plastic polymer or
equivalent with a minimum thickness of ¼ inch. 4. No
mounting with zip ties or chains. 5.
Must be captured between two ⅛ inch by 1 inch metal plates and
mounted to resist folding back. 6.
Each flap must be installed with a minimum of five ¼ inch bolts. 7.
Must be centered on tire. Stadium Unlimited
Buggy 1.
Minimum weight is now 1800 lbs. Stadium Limited
Buggy: 1.
Restrictor plates are no longer required, but may be left in place and
bored out if needed as a spacer. 2.
Carburetor butterfly may have a hole drilled in it for easier idling. 3. VW after market rods are allowed. The minimum length is 5.395 +/- .10. 1 rod must remain untouched. |